DeLorme Earthmate GPS PN-60 Instrukcja Użytkownika Pobierz pdf (Strona 5)

4 Getting Started | Earthmate PN-60 User Manual

To Do this

Install batteries and SD card

1. Unscrew the D-rings on the back of the device until you can remove the battery

cover.

2. Optional. To insert an SD card, gently press down the SD card latch, insert the

card in the slot, and press down the slot to close the latch. Note Do not lift the

SD card latch as this could cause damage.

3. Insert the batteries according to the polarity symbols inside the battery

compartment.

4. Replace the back cover and screw in the D-rings.

Check battery type

Go to Settings > System > Battery Type and make sure the correct battery type is

selected; this ensures that the battery indicator displays the correct amount of battery

life remaining.

View battery indicator The battery indicator is on the Home Page (see page 9).

Charge DeLorme Li-ion

battery in the PN-60

Install the battery in the device.

To leave the device powered on while charging, power it on and connect the USB

cable to the computer. On the Home Page, the battery indicator displays a plug.

To put the device in charging mode, power it off and connect the USB cable to the

computer. The light indicator below the bottom left corner of the screen ashes red.

When the device is fully charged, the light is green.

Improve battery life

• Automatically turn off the backlight after 15 seconds; go to Settings > Display > Backlight Timer > 15 sec.

• Use the power saving option; go to Settings > System > GPS Setting > Power Saving.

• Turn off the GPS receiver when inside. Go to Settings > System > GPS Setting > Off.

From the Satellites Page, go to MENU > Turn Off GPS.

• Use batteries with higher milliamp-hour (mAh) ratings.

Battery polarity symbols

SD card slot

SD card latch

USB cable connector

1 2 3 4 5 6 7 8 9 10 ... 71 72

Brak uwag

DeLorme Earthmate GPS PN-60 Instrukcja Użytkownika Strona 5